Bitten Downloads

Bitten 0.6b3 works with Trac 0.11.x and Trac 0.12.x, supporting a single (default) repository.

Full Trac 0.12 multi-repository support is a target for a future milestone:0.7, see ticket:342 and ticket:433 for discussion.

Latest Release

Currently latest release: 0.6b3

Bitten (master+slave)	BittenSlave (slave only)
​Python 2.4 egg	​Python 2.4 egg
​Python 2.5 egg	​Python 2.5 egg
​Python 2.6 egg	​Python 2.6 egg
​tar.gz source
​zip source
​Win32 installer	​Win32 installer
​Win64 installer	​Win64 installer

All releases: ​http://ftp.edgewall.com/pub/bitten/ or ​ftp://ftp.edgewall.com/pub/bitten/

Latest Development Source Code

The ​Subversion repository URL for the Bitten project is at:

​http://svn.edgewall.org/repos/bitten/

Alternative 1: Checkout and install

The latest revision can be checked out with the following command:

svn co http://svn.edgewall.org/repos/bitten/branches/0.6.x bitten-0.6.x
# or
svn co http://svn.edgewall.org/repos/bitten/trunk bitten-trunk

(Alternatively, you can use https for an encrypted connection, which also helps getting around clueless firewalls that haven't heard of ​WebDAV yet.)

Then change into the checkout directory and run setup.py:

cd bitten-<version>
python setup.py install   # master + slave
# or
python setup.py --without-master install   # slave only

Alternative 2: easy_install from URL

If you have a recent version of ​Setuptools installed, you can just do:

easy_install http://svn.edgewall.org/repos/bitten/branches/0.6.x
# or
easy_install http://svn.edgewall.org/repos/bitten/trunk/

Earlier releases

Old releases are ​still available from Sourceforge (the last one was 0.5.3), but at this time it is strongly recommended that you use current current source and releases as we prepare for 0.6 release. Old releases (0.5.x) support Trac 0.10.x, but can not be used for Trac 0.11. For Trac 0.11+, 0.6 is required.

Pre-0.6 releases are no longer supported by the Bitten project!